Rebar Weight & Quantity Calculator (#3 to #18)
Count and weigh reinforcing bars for a slab or mat by spacing, or from a bar list. Laps are added where a run is longer than the stock bar. The calculation runs in your browser. A free account is needed after 3 calculations and to download results. Saving a project stores the inputs with your account.
Guide: Rebar Weight & Quantity
- Load the sample to see typical inputs, then replace every value with your project data.
- Check the units shown next to each input.
- Results and the drawing update as you type. Read the step-by-step table and any warnings.
Code basis and design decisions
- Unit weights: nominal weights of the standard inch-pound bar sizes (lb/ft): #3 0.376, #4 0.668, #5 1.043, #6 1.502, #7 2.044, #8 2.670, #9 3.400, #10 4.303, #11 5.313, #14 7.650, #18 13.600.
- Mat bar count: n = floor((W − 2 × cover) / spacing) + 1 each way; bar run = panel dimension − 2 × cover.
- Laps: a run longer than the stock bar gets n − 1 laps with n = ceil((run − stock)/(stock − lap)) + 1. Lap = an editable engineering default: a multiple of db (40 db preset) or inches. Use the lap on the drawings. #14 and #18 bars are normally spliced mechanically, not lapped.
- Hooks, bends, chairs and accessories are not included: add them to the bar list.
Notes & limits
- Weights are nominal. Mill tolerance and supplier rounding make delivered tonnage differ slightly.
- Laps in the contract documents govern.