Wood Connection Calculator NDS dowel yield modes and withdrawal
NDS dowel-yield modes and withdrawal. Defaults that are a range (load duration, wet service, temperature, angle to grain) start at the low-capacity end. A value you change is marked user override. The page does not compute Z; the engine does.
Main speciesDouglas Fir-Larch Southern Pine Hem-Fir Spruce-Pine-Fir Spruce-Pine-Fir (South)
Specific gravity G main
Side materialWood Steel
Side speciesDouglas Fir-Larch Southern Pine Hem-Fir Spruce-Pine-Fir Spruce-Pine-Fir (South)
Specific gravity G side
Steel side Fe (psi)user entered when the side is steel; no steel Fe table is loaded
ShearSingle Double
FastenerBolt Lag screw Nail Wood screw
Fastener size
Diameter (in)
Fyb (psi)leave blank to use the fastener default
Main bearing length lm (in)
Side thickness ls (in)
Angle to grain, main (deg)default 90 (perpendicular)
Angle to grain, side (deg)
Load to grainPerpendicular Parallel default perpendicular (larger edge distance)
Load durationPermanent (CD 0.9) Occupancy live (CD 1.0) Snow (CD 1.15) Roof live (CD 1.25) Wind or seismic (CD 1.6) NDS Table 2.3.2, default permanent
Wet serviceWet Dry default wet
Temperature (F)default 150 F
Fasteners
Fasteners in one row
Row spacing (in)
Lateral demand (lb)
Withdrawal demand (lb)
End distance (in)
Edge distance (in)
Spacing parallel to grain (in)
Attached member spacing (in)Table 12.5.1B, perpendicular to grain. Blank uses 4D, the parallel-to-grain spacing of the attached member.
Spacing perpendicular to grain (in)
Grade, main (for E only)
Nominal, mainNot used 2x4 2x6 2x8 2x10 2x12 4x4 4x6 6x6
End grain, main memberNo (side grain) Yes NDS 12.3.3.4 uses Fe perpendicular, and 12.5.2.2 applies Ceg = 0.67
ToenailNo Yes nails only, NDS 12.5.4
Fabricated wetNo Yes NDS Table 11.3.3
Penetration (in)withdrawal length; lag tip is excluded by the entry
Member stressTension Compression default tension end distance
Loaded edgeLoaded Unloaded
PreboredNo Yes recorded; Table 12.5.1C is not a nail minimum
Lateral diameterRoot Dr (12.3.7.1) Shank (12.3.7.2) shank only when threads are ≤ 1/4 of the bearing length
Cross-grain detailingNot detailed Detailed for shrinkage NDS 12.5.1.3, 5 in between outermost rows
Load hand-calc example Check connection
Engine response (unrounded)